Blum 170 Degree Hinge for Back-to-Back Overlay Cabinets – BundleSelf-Closing

Introduction

• Blum 170 degree hinge bundle for back-to-back overlay doors on frameless cabinets.
• Available in self-closing and free swinging functionalities.
• The hinge and mounting plate attach to each other by snapping on.
• Please see the minimum reveal sheet below to determine if this hinge bundle will work for you.

What’s Included

• 1 Blum 170 Degree Hinge
• 1 Blum 0mm System Screw Frameless Mounting Plate
• Two #6 x 5/8″ Flat Head Wood Screws for the hinge

Mounting Screws for Mounting Plate (Not Included)

• Depending on cabinet side wall thickness you will need either of the following screws for the mounting plate:
  • For cabinet wall thickness of 5/8″ to 7/8″, you will need to use back to back mounting screws.
  • For cabinet wall thickness of 1″ or greater, use #6 x 5/8″ screws.
• Note that only two back to back screws are required for two hinges, whereas you would need four #6 x 5/8″ screws for two hinges.

Optional Accessories – Available for purchase separately:

• Cover Plate for the Hinge Arm – Hides the screws on the hinge arm providing a cleaner appearance (SKU 268003)
• Soft-Close Add-On Device – Eliminates slamming of the door and dampens the closing action (SKU 268234)
  • Note: Soft close does not work with free swinging hinge.
• Plastic Dowels, used on manufactured wood products where wood screws do not hold well (SKU 652368)
• Restriction clip. Limits angle of opening to 130 degrees (SKU 652033)
• Blum Touch Latch for Self-Closing Doors (SKU 268822)
• 35mm Forstner Bit, for new installations (SKU 204000)
• Ecodrill, installation jig, for new installations (SKU 701000)

USA