System Screw 0mm Blum Clip Top Frameless Mounting Plate

Introduction

• This Blum mounting plate mounts on the inside wall of the cabinet (not on the face frame).
• For use with Blum’s Half Crank Clip Top hinges where you would use back-to-back screws or system screws.
• Mounting plates are sized by height. Each mounting plate in combination with the bore distance of the hinge creates the door overlay (for an overlay door) or the reveal (for an inset door or back to back door)
• For back-to-back door installations, we offer Back-to-Back screws. Back-to-Back installations are where two doors are installed to the same cabinet side panel. It is recommended that the mounting plates for these hinges be installed with Back-to-Back screws (a male/female type screw) so that the screws do not interfere with each other.

Replacements

• When replacing worn out or broken Blum hinges, it is a good idea to replace all the hinges and mounting plates on your door at the same time.

Gate Hinges