SureClose Safety Weld-On HingeSureClose Self-Closing Hinge 57SF-AT90-W

Introduction

• NOTE: Post mounting brackets sold separately. The recommended setup requires two hinges and two mounting brackets.
• SureClose hinges for weld-on applications.
• Allows a gate to swing to a maximum of 90 degrees in one direction.
• A separate gate stop (not included) must be installed to restrict gate from opening past 90 degrees. See the documents found under Downloads for further details.
• Hinge requires face of gate and post to be flush.
• Requires minimum post size of 3″ x 3″.
• Self-closing or non self-closing versions available.
• See swing diagram above for a clear visual representation of hinge functionality.
• Hydraulics are concealed within the post, providing a controlled and quiet close in a tamper resistant design that will not leak.
• Adjustable self-closing speed.
• Does not offer resistance if closed quickly in an emergency.
• Features dual thrust ball bearings to help withstand heavy loads.
• Hinge gap between frame and gate is 1/2″.

These hinges can be used in any of the following combinations:

• Use 2 of our SKU 928536 to self-close a gate up to 260 pounds*.
• Use 1 of our SKU 928536 and 1 of SKU 928526 to self-close a gate up to 180 pounds*.
• Use 2 of our SKU 928526 to hold a gate up to 1500 pounds* (will not self-close).
• * Weight ratings based on a maximum gate size of 72″ high x 40″ wide.

Gate Hardware